Skip to main content

Extension

Open Main MenuClose Main Menu

Livestock and Poultry Drinking Water Quality: Understanding Your Water Test Report

Understanding Your Water Test Report

Water used by livestock will occasionally contain elements or substances at levels that may reduce performance or cause toxicity. The source of the contaminants may be natural or man-made. In either case, if you suspect your water supply is harming your livestock, the first step in diagnosing the problem is to collect a representative water sample and submit it to your County Extension office for a livestock water test.

 

What Do the TEST RESULTS MEAN?

 

The OSU Soil, Water and Forage Analytical Laboratory tests livestock water samples for pH, total soluble solids, electrical conductivity, nitratenitrogen, sulfate, and concentrations of major elements. A summary of major tests follow.


The pH reflects the acidity or alkalinity of the water. A pH of 7 is neutral. A pH value below 7 is acid, and a pH value above 7 is alkaline. It is preferred that the water has a pH between 6.0 and 8.5, but most animals can tolerate water slightly outside of this range (5.5-9).

 

Total dissolved solids (TDS) refer to salt particles that are dissolved in a water sample. Salt particles include the substances that form common table salt (sodium and chloride) as well as calcium, magnesium, potassium, sulfate, nitrate, and carbonate. When salts mix with water, they dissolve into ions that have positive and negative electrical charges. As the amount of dissolved salt increases, the number of charged ions increases, and the ability of the water to conduct electricity becomes greater. As a result, the amount of TDS in a water sample can be estimated by measuring the electrical conductivity (EC) of the sample. Table 1 presents guidelines for interpreting TDS test results and determining the associated livestock risks.

 

Table 1. GUIDELINES FOR INTERPRETING LIVESTOCK AND POULTRY WATER TEST RESULTS FOR TOTAL DISSOLVED SOLIDS.

  Total Dissolved Solids Content (ppm) Interpretation
  <1,000 Considered low. Excellent for all classes of livestock and poultry.
  1,000-2,999 Very satisfactory but may cause a mild temporary diarrhea in animals not accustomed to the water.
  3,000-4,999 Satisfactory for livestock; poor water for poultry, especially turkeys. Water may be refused when first offered to animals or cause temporary diarrhea.
  5,000-6,999 Marginal quality for livestock. Avoid these waters for pregnant or lactating animals. Not suitable for poultry.
  7,000-10,000 Avoid use for all animals if possible. Considerable risk for pregnant or lactating animals. Older animals may be tolerant under less stressful conditions.
  >10,000 Unsafe. Avoid under all conditions.

ppm=parts per million

 

National Research Council. 1974. Nutrients and Toxic Substances in Water for Livestock and Poultry. Washington D.C., National Academy of Sciences.

 

For more information on understanding your livestock and poultry water test, please consult your local OSU County Extension Office.

 


Nitrates are a salt that can be particularly harmful to livestock, and are therefore included in the livestock water test. Table 2 presents guidelines for interpreting nitrate-nitrogen test results and determining the associated livestock risks. In some cases, the nitrate content of feed and forage should also be considered when assessing the risk of nitrates in water.

 

Mineral concentrations are also important water quality parameters for poultry and livestock. The upper limits of tested and selected untested minerals are listed in Table 3. For more details of interpretations for livestock water quality, please use the online interactive program at http://soiltesting.okstate.edu/test-interpretations.

 

Table 2. GUIDELINES FOR INTERPRETING LIVESTOCK AND POULTRY WATER TEST RESULTS FOR NITRATE-NITROGEN.

  NO3 (ppm) NO3 - N (ppm) Comment
  0-44 0-10 Safe for consumption by livestock and poultry.
  45-132 10-20 Generally safe in balanced diets with low nitrate feeds.
  133-220 20-40 Could be harmful if consumed over long periods.
  221-660 40-100 Animals at risk. Potential death losses.
  661-800 100-200 Unsafe. High potential for death losses.

National Research Council. 2001. Nutrient Requirements of Dairy Cattle, 7th revised edition . Washington D.C., National Academy of Sciences.

 

Collecting a Proper Water Sample

Use a clean 4 oz. plastic container to collect your water sample. Plastic bottles can be obtained from your County Extension office. Prior to filling the bottle, rinse it three times with the water to be tested. Try and leave as little air as possible in the bottle after collecting the sample. Make sure the sample is representative of the water being consumed by the livestock. If contamination of an isolated water supply is suspected, it is best to also collect and submit a water sample from a nearby supply that is known to be uncontaminated.

 

Just because a water sample passes the livestock water test does not mean it is safe for all livestock. Other elements or substances not tested for may be present at harmful levels. Recommended concentration limits for some potentially toxic substances not tested by the OSU laboratory are presented in Table 3. Pesticide contamination may also make water harmful to livestock. If you suspect a water supply is contaminated with potentially toxic substances or pesticides, another reputable laboratory should be consulted for testing your sample.

 

a brown jar with a green lid.

 

 

 

 

 

 

 

Table 3. Recommended Limits of Concentration of Some Potentially Toxic Substances in Drinking Water for Livestock and Poultry*

Substance Safe Upper Limit of Concentration (ppm)
Arsenic 0.2
Barium Not established§
Boron 5
Cadmium 0.05
Chloride 600
Chromium 1.0
Cobalt 1.0
Copper 0.5
Cyanide Not established§
Fluoride 2.0
Iron Not established§
Lead 0.1
Manganese Not established§
Mercury 0.010
Molybdenum Not established§
Nickel 1.0
Nitrate-N 100
Nitrite-N 10.0
Sodium 1000
Sulfate 1000
Vanadium 0.1

*The concentration values in this table are generally far below the LD50 intakes of the various elements. §No limit is given for a number of elements since experimental data available are not sufficient to make definite recommendations.

 

Soil, Water & Forage Analytic Laboratory

Email: soiltesting@okstate.edu
Website: www.soiltesting.okstate.edu

 

 

Hailin Zhang, Ph.D.

Laboratory Director

 

Josh Payne, Ph.D.

State Poultry Specialist

Was this information helpful?
YESNO
Fact Sheet
Nutritive Value of Feeds

By Paul Beck, David Lalman and Alexi Moehlenpah. To ensure their animal's diets are balanced nutritionally, producers must know available feed nutrient composition, physical and digestive characteristics and the animal's nutrient requirements.

Beef CattleLivestockLivestock Health, Disease & NutritionLivestock NutritionPastures & ForageSilage
Fact Sheet
Nutrient Requirements of Beef Cattle

This circular describes dry matter intake, protein, and energy needs of various classes of beef cattle.

Beef CattleLivestockLivestock Health, Disease & NutritionLivestock Nutrition
Fact Sheet
Fact Sheet
VIEW ALL
Back To Top
MENUCLOSE