Skip to main content

Extension

Open Main MenuClose Main Menu

Current Report: Oklahoma Farm and Ranch Custom Rates, 2015-2016

This Current Report summarizes data collected from Oklahoma farmers, ranchers and custom operators during the summer and fall of 2015. Custom work is defined as machine operations performed for the customer with the custom operator furnishing the machine, fuel, labor and other inputs directly associated with the machine. Custom operators do not usually furnish materials such as seed or fertilizer unless it is explicitly stated. The change in custom rates was mixed since the 2013 survey. While lower fuel prices may have helped stabilize custom rates, higher repair and ownership costs more than offset the cost savings in many situations. Approximately 610 surveys were returned with usable data.

 

Summary Procedure

The rates quoted herein were collected by a survey of both farmers and custom operators. A list of over 150 operations was provided from which each respondent quoted rates for only selected operations.  Some respondents quoted rates for only one or two operations while others were familiar with rates for many of the machines listed. “Fair” rates are negotiated. Regional or state average rates may be used as a beginning point for discussion. However, differences in operations, requirements, and circumstances may impact rates.

 

The rates summarized on the inside pages were edited to remove those replies for which the respondent’s interpretation of the information being requested did not match the interpretation of other respondents.

 

Interpreting the Rate Tables

A statewide rate summary for each operation is quoted in the included table. If available, separate quotes are listed for each area of the state as shown in Figure 1. The number of estimates obtained, the average rate, and the lowest and highest rates reported are shown. The average rate for a specific operation provides an estimate of the prevailing charge with its reliability improving as the number of responses increase.The cost of following up with individual surveys prohibited questioning or affirming doubtful replies. In most cases the number of observations was insufficient to allow statistical analysis. You must interpret these results, therefore, with these limitations in mind.

Regions used in reporting Custom Rate Survey results.

Figure 1. Regions used in reporting Custom Rate Survey results.

 

Figure 2 shows the distribution of survey responses for  operations with at least 50 observations. For example, a distribution of 320 responses for raking hay is one of several graphs shown. None of the respondents reported a rental rate less than $10 per acre, 15% reported a rental rate between $1.00 and $3.00 per acre, 27% reported a rental rate between $3.00 and $5.00 per acre, 33% reported a rental rate between $5.00 and $7.00 per acre, 9% reported a rental rate between $7.00 and $9.00 per acre, and 16% of the respondents reported a rental rate of $9 or more per acre.

If you are interested in a rate quotation for a specific operation in an area which shows a small number of reports, consider rates for other areas of the state where the operation is more common  or refer to the statewide summary.  Additional adjustments for field size, terrain and soil type may be necessary.

Figure 2 cont'd.

 

Reporting Regions

Area rates are summarized for the State of Oklahoma as shown in Figure 1 (page 1).  Regional differences are apparent in the rate table with higher rates prevailing when:

  • Fields are small.
  • Soils are heavy.
  • Slopes are steep.
  • Machines are scarce.
  • Custom operators are not available.

Rates tend to be lower than expected when exchange work is common between relatives and neighbors. Under these circumstances, fixed costs of ownership such as depreciation and interest on investment (sometimes even labor) tend to be discounted when a rate is established for a particular job.

 

Reporting Region Table

Reporting Region Table cont'd

 

Custom Service vs. Ownership

Individual circumstances–cash flow, ownership and operating costs, labor availability, reliability and timeliness of custom operators, pride of ownership–will influence an individual’s decision on whether to buy or lease machinery and equipment or custom hire work done. A worksheet at the end of this article is designed to help evaluate the cost of machinery ownership and operation.

 

Possible Advantages of Using Custom Operations

  • Ownership costs are avoided.

  • Capital and labor can be channeled to other uses.

  • Machine use can be readily adjusted to changes in crop mix and market conditions.

  • Specialized operations may benefit from experience and skilled operator.

  • Jobs may be completed faster using several machines.

 

Possible Disadvantages of Using Custom Operations

  • Service may not be available at the best time.

  • Reliability of the custom operator may not be known.

  • Rates may be excessive in special situations.

Each manager must choose the best combination of owned and hired machines. The quotations here will be helpful in estimating custom costs and to provide a base figure for agreement on a rate when well established local rates are not available. If you have questions, ask your Extension Educator- Agriculture or Area Agricultural Economics Specialist for additional information.

 

Considerations to Keep in Mind

Keep in mind there is a wide variation in rates charged for most jobs, even within the same geographic area, partly because some custom work is done for friends, relatives, and neighbors at reduced rates, partly because some custom work is done late by farmers who do their own work first and therefore do not attempt to include the full cost of machine ownership in their rates, and partly because it is easy to under‑estimate the full cost of ownership and operation of machinery.

 

A small number of reports for a given machine in a particular area may not be representative. In this case, it is particularly important to check rates in other areas or statewide where a larger number of reports are found.

 

Costs of Ownership and Operation

 

Damona Doye
Regents Professor and Extension Economist

 

Roger Sahs
Extension Assistant Specialist

Was this information helpful?
YESNO
Fact Sheet
From Cash Records to Cost of Production

By Rodney Jones, Courtney Bir, and Brent Ladd. This fact sheet guides producers through the steps to identify cash and noncash costs, allocate these costs to the appropriate enterprise, and calculate their cost of production.

Budgets & RecordkeepingBusiness Planning & ManagementFarm & Ranch Finances
Fact Sheet
The Economic Contribution of the Cotton Industry in Oklahoma

By Andrew J. Van Leuven, Jeff Vitale, Dayton M. Lambert, Phil Kenkel, Hannah E. Shear and Emily Norris. Learn about the cotton industry's value in the state of Oklahoma.

Business Strategy & MarketingCommunity & Rural ImprovementCottonCropsEconomic DevelopmentFarm & Ranch FinancesMarket Outlooks
Fact Sheet
Farmers in Transition: Farm Family Decision-Making

By Courtney Bir, Rodney Jones and Brent Ladd. Learn what it takes to be an effective decision maker, the barriers that farmer managers might face, how to overcome those barriers and successfully implement decisions.

Business Planning & ManagementFarm & Ranch Finances
Fact Sheet
How Likely are Calf Value-Added Management Practices to Pay Off?

By Brian R. Williams, Eric DeVuyst, Derrell S. Peel, Kellie Curry Raper. Learn about the probability of success with calf value-added management practices.

Beef CattleFarm & Ranch FinancesLivestockMarket Outlooks
VIEW ALL
Back To Top
MENUCLOSE